Maintenance of high frequency welded tube machine group

1. In the process of use, we must strictly operate according to the operation procedures in the operation manual, and we can’t let the machine run and use overload. In addition, before complaining about production, that is, before the operation of the machine, we must check whether all parts of the machine can work normally and whether there is any fault. Only when all parts and indicators of the machine are positive Only under normal conditions can the machine be started up and put into production, otherwise it will cause the loss of machinery.

 

2. After checking the parts of the high frequency welded tube unit, we can start the machine again. In the production process of the machine, we should ensure the stability of the temperature and production status of the machine. If the machine fails, we must stop production in time and check what part of the machine is wrong, so as not to cause more losses. The main faults include unstable operation of the machine, grinding of the machine, and whether there is abnormal noise in the operation process. If there is any problem, it should be checked in time.

 

3. After the machine has been used for a period of time, we should pay attention to the regular lubrication and cleaning of the machine to ensure that the machine is clean. Only in this way can the machine run normally and it is relatively light in the use process. The aging parts in the machine must be replaced in time to ensure the normal operation of the machine at any time. In addition, when the machine is not suitable, it is also necessary to take good care of the high-frequency welded tube machine unit, and do not arbitrarily discard it.